assign
softkey,
A-22
attenuator, uncouple, U-l
attenuator uncouple, M-14
attenuator, value set, S-59
auto fill increment, A-23
auto fill number of points, A-24
auto fill start, A-25
auto fill stop, A-26
automatically set sweep time, S-76
automatic sweep time, l-10
automatic trigger, stepped sweep, S-69
auto track, A-27
auto track failed message,
2a-1
auxiliary interface connector, C-6
auxiliary output connector, C-5
B
bandwidth
ALC, A-9, A-10, A-11
AM, A-12, A-13
amplitude modulation, A-12, A-13
beginning frequency
flatness correction, A-25
frequency list, A-25
bits
in general status register model, l-106
summary bit in general status register model, l-107
blank display, B-l
BNC connectors, C-4
Boolean parameters
discussed in detail, l-85
explained briefly, l-75
brackets, angle, l-64
BUS
trigger source defined, 1-119
C
cabinet, clean, 4-5
cables
HP-IB, C-7
calco fail, F-3
calibrate sweep span always, S-74
calibrate sweep span once, S-75
calibration
full user, F-19
sweep span, F-15
calibration failed message, 2a-2
calibration, user functions, U-3
calman
fail, F-4
calY0
fail, F-4
center frequency, 1-8, C-l
CW coupled, C-13
center frequency marker, C-l
CF/span
sweep mode, zoom, Z-l
change correction value, C-3
change interface address, 3-8
Index-3
To Next Page
Loading...
