HP 8360 B Series - Page 476

doubler amp mode on, D-9
doubler amp softkeys, D-l
down arrow, A-21
dual source control, S-64
dwell coupled, D-10
dwell time
frequency point, E-3
list array, all points, G-l
stepped frequency mode, S-67
dwell time coupled, D-10
EEROM fail, F-3
EEROM failed, lost CAL message, 2a-2
EEROM failed message, 2a-2
enable register, l-107
in general status register model, l-106
^END, l-64
^END[end], l-81
ending frequency
flatness correction, A-26
frequency list, A-26
enter correction, E-l
enter frequency value
flatness, E-2
enter list dwell, E-3
enter list frequency, E-4
enter list offset, E-4
enter statement, l-6 1
entry area, 1-4, E-5
entry keys, E-5
entry on LED, l-5
entry on/off, E-5
EOI, l-64, 1-81
EOL, suppression of, 1-61
equipment supplied, 3-l
erase active array entry, D-4
erase array, D-3
erase array entries, D-3
erase memory, C-2
erase undefined entry, D-4
erase user defined menu, U-6
erase user defined softkey, U-5
error messages, 2-1, 2a-1-8
error queue, clear, S-14
*ESE, S-14
*ESR?, S-14
event commands, l-72
event detection trigger state
details of operation, 1-112
in general programming model, l-110
event register, l-107
in general status register model, l-106, l-107
events
event commands, l-72
Index-7