HP 8360 B Series User Manual

SWEPT SIGNRL
GENERATOR
--
1 FLATNESS
1 CORRECTED
, OUTPUT PORT
2y---~ ------ A
----
DEVICE
UNDER
TEST
_ -P;EOR
J
Figure l-19. Creating a User
Flatness Array
POWER NETER
-00cl
P
. 6 .El
Q
For this example, refer to menu map 5, POWER.
1. The equipment setup shown in Figure 1-19 assumes that if your
setup has an external leveling configuration, the steps necessary
to correctly level have been followed. If you have questions about
external leveling, refer to “Externally Leveling the Swept Signal
Generator”.
Setup Power Meter
2. Zero and calibrate the power meter/sensor.
3. Connect the power sensor to the point where flatness corrected
power is desired.
Setup Swept Signal Generator Parameters
4. On the swept signal generator, press (PRESET).
5. [POWER LEVEL) @ (dB0). This sets the test port power to
+5 dBm (PO maX - Ppath loss).
Create A Frequency List
6. On the swept signal generator, press FREQUENCY (MENU).
7. Select List Menu Enter List Freq a@&. This enters
5 GHz as the first frequency in the list array. Entering a
frequency automatically sets the offset to 0 dB and the dwell to
10 ms.
8. Enter 18, 13, 11, and 20 GHz to complete this example array.
Getting Started Advanced 1-37

HP 8360 B Series Specifications

General

Brand	HP
Model	8360 B Series
Category	Portable Generator
Language	English