HP 8360 B Series User Manual

WEPT SIGNAL
GENERATOR
HP 437B
POUER METER
POUER SENSOR
WEPT SIGNAL
OENERRTOR
HP 4378
POUER NETER
SOURCE MODULI
INlERFACl
NICROURVE IWPLIFIER
‘F OUT
POUER SENSOR
Figure l-20.
Creating Arbitrarily Spaced Frequency-Correction Pairs
in a Swept mm-wave Environment
For this example, refer to menu map 5, POWER.
1. The equipment setup shown in Figure l-20 assumes that
you have followed the steps necessary to correctly level the
configuration. If you have questions about external leveling, refer
to “Externally Leveling the Swept Signal Generator”.
Setup Power Meter
2. Zero and calibrate the power meter/sensor.
3. Connect the power sensor to test port.
4. Enter and store in the power meter, the power sensor’s cal factors
for correction frequencies to be used.
l-40 Getting Started Advanced

HP 8360 B Series Specifications

General

Brand	HP
Model	8360 B Series
Category	Portable Generator
Language	English