HP HPE Synergy 12000 Frame

Performing a frame link module factory resetPerforming a frame link module factory reset
NOTE:NOTE:
This procedure only factory resets the frame link modules installed in the frame. It does not factory reset any other
components installed in the frame.
NOTE:NOTE:
The frame link module can be factory reset by pressing the front panel reset button until the front panel UID flashes or
by using the HPE Synergy Console Actions menu. Hewlett Packard Enterprise recommends using the HPE Synergy
Console to perform a factory reset.
ProcedureProcedure
1. Connect to the HPE Synergy Console.
2. Select Actions > FLM Diagnostics > Factory Reset.
3. Click Yes, reset.
Performing a frame link module factory reset 167