HPE Synergy 40Gb F8 Switch Module LEDs and buttonsHPE Synergy 40Gb F8 Switch Module LEDs and buttons
ItemItem DescriptionDescription StatusStatus
1 Interconnect link port LEDs Solid green = Linked
Solid red = Error detected .
Off = No link
2 QSFP+ port LEDs The four LEDs above each port correspond to the 10GbE or 8Gb FC
channels of the port. The LEDs display one of four modes:
Ethernet mode:
Solid green = The port is configured as an Ethernet port.
Off = The port is not configured as an Ethernet port.
PID mode:
Solid green = The port is configured as an uplink port.
Solid amber = The port is configured as a stacking port.
Solid purple = The port is configured as a mirrored port.
Solid red = Error.
Solid blue = Activated by OneView for port identification.
Off = The port is not configured.
Link/Activity mode:
Solid green = 10Gb Ethernet link
Flashing green = 10Gb Ethernet activity
Solid amber = 8Gb FC link
Flashing amber = 8Gb FC activity
Solid purple = 40Gb Ethernet link
Flashing purple = 40Gb Ethernet activity
Solid Red = Error
Off = No link
Fibre Channel (FC) mode:
Solid green = The port is configured as an FC port.
Off = The port is not configured as an FC port.
To switch between the LED modes, press the NEXT button.
3 NEXT button Selects the QSFP+ port LED mode.
4 Reset pin-hole Resets the module
1
To Next Page
Loading...
Need help?
General
