HP HPE Synergy 12000 Frame User Manual

Component installationComponent installation
The following sections contain installation instructions for the individual frame components. The images included in these instructions
are intended to illustrate how the components are installed. These images are not intended to indicate the location for installation. Install
the component in the bay from which it was removed earlier in this document.
There is no specific installation order requirement for the frame components, however Hewlett Packard Enterprise recommends
installing all front components first, followed by all rear components.
All components must be installed and cabled before you power up the frame.
The frame and components automatically power on when power is connected.
Component installation 79

HP HPE Synergy 12000 Frame Specifications

General

Form Factor	Rack-mountable
Maximum Compute Modules	12
Management Module	HPE Synergy Composer
Cooling	Redundant fan modules
Power Supply	Redundant power supplies
Networking	HPE Synergy 12000 Frame Interconnect
Product Type	Blade Enclosure
Width	44.5 cm
Compliance	FCC, VCCI, BSMI, CCC, KCC, RoHS
Depth	36.25 in (92.08 cm)