HP MSR SERIES

300
ESP authentication hex key:
-----------------------------
Sequence number: 2
Mode: isakmp
-----------------------------
The policy configuration is incomplete:
Remote-address not set
ACL not specified
Transform-set not set
Description: This is my first IPv4 Isakmp policy
Security data flow:
Selector mode: standard
Local address:
Remote address:
Transform set:
IKE profile:
SA duration(time based):
SA duration(traffic based):
SA idle time:
-------------------------------------------
IPsec Policy: mycompletepolicy
Interface: LoopBack2
-------------------------------------------
-----------------------------
Sequence number: 1
Mode: manual
-----------------------------
Description: This is my complete policy
Security data flow: 3100
Remote address: 2.2.2.2
Transform set: completetransform
Inbound AH setting:
AH SPI: 5000 (0x00001388)
AH string-key: ******
AH authentication hex key:
Inbound ESP setting:
ESP SPI: 7000 (0x00001b58)
ESP string-key: ******
ESP encryption hex key:
ESP authentication hex key:
Outbound AH setting:
AH SPI: 6000 (0x00001770)
AH string-key: ******