HPE FlexNetwork 5510 HI Series Layer 3 - Ip Routing Configuration Guide

146
Step Command Remarks
4. Return to system
view.
quit
N/A
5. Enter interface view.
interface
interface-type
interface-number
N/A
6. Configure a DIS
name.
isis dis-name
symbolic-name
By default, no DIS name is configured.
This command takes effect only on a
router enabled with dynamic system ID
to host name mapping.
This command is not available on P2P
interfaces.
Enabling the logging of neighbor state changes
With this feature enabled, the router delivers logs about neighbor state changes to its information
center. The information center processes the logs according to user-defined output rules (whether to
output logs and where to output). For more information about the information center, see Network
Management and Monitoring Configuration Guide.
To enable the logging of neighbor state changes:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter IS-IS view.
isis
[ process-id ] [
vpn-instance
vpn-instance-name ]
N/A
3. Enable the logging of
neighbor state changes.
log-peer-change
By default, the logging of
neighbor state changes is
enabled.
Enabling IS-IS ISPF
When the network topology changes, Incremental Shortest Path First (ISPF) computes only the
affected part of the SPT, instead of the entire SPT.
To enable IS-IS ISPF:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter IS-IS view.
isis
[ process-id ] [
vpn-instance
vpn-instance-name ]
N/A
3. Enable IS-IS ISPF.
ispf enable
By default, IS-IS is
disabled.
Configuring IS-IS network management
This task includes the following configurations:
• Bind an IS-IS process to MIB so that you can use network management software to manage the
specified IS-IS process.
• Enable IS-IS notifications to report important events.

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English