204
To inject a local network (IPv6):
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance
view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Enter BGP IPv6 unicast
address family view or
BGP-VPN IPv6 unicast
address family view.
address-family ipv6
[
unicast
]
N/A
4. Inject a local network to the
IPv6 BGP routing table.
network
ipv6-address
prefix-length [
route-policy
route-policy-name ]
By default, BGP does not
advertise any local network.
Redistributing IGP routes
Perform this task to configure route redistribution from an IGP to BGP.
By default, BGP does not redistribute default IGP routes. You can use the default-route imported
command to redistribute default IGP routes into the BGP routing table.
Only active routes can be redistributed. To view route state information, use the display ip
routing-table protocol or display ipv6 routing-table protocol command.
The ORIGIN attribute of BGP routes redistributed from IGPs is INCOMPLETE.
To configure BGP to redistribute IGP routes (IPv4):
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter BGP view or BGP-VPN
instance view.
• Enter BGP view:
bgp as-number
• Enter BGP-VPN instance
view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
N/A
3. Enter BGP IPv4 unicast
address family view or
BGP-VPN IPv4 unicast
address family view.
address-family ipv4
[
unicast
]
N/A
4. Enable route redistribution
from the specified IGP into
BGP.
import-route
protocol
[ { process-id |
all-processes
}
[
allow-direct
|
med
med-value |
route-policy
route-policy-name ]
* ]
By default, BGP does not
redistribute IGP routes.
5. (Optional.) Enable default
route redistribution into BGP.
default-route imported
By default, BGP does not
redistribute default routes.
To configure BGP to redistribute IGP routes (IPv6):
To Next Page
Loading...
Need help?
General
