EasyManuals Logo

HPE FlexNetwork 5510 HI Series Layer 3 - Ip Routing Configuration Guide

HPE FlexNetwork 5510 HI Series
486 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #189 background imageLoading...
Page #189 background image
178
Configuring BGP
Overview
Border Gateway Protocol (BGP) is an exterior gateway protocol (EGP). It is called internal BGP
(IBGP) when it runs within an AS and called external BGP (EBGP) when it runs between ASs.
The current version in use is BGP-4 (RFC 4271).
BGP has the following characteristics:
• Focuses on route control and selection rather than route discovery and calculation.
• Uses TCP to enhance reliability.
• Measures the distance of a route by using a list of ASs that the route must travel through to
reach the destination. BGP is also called a path-vector protocol.
• Supports CIDR.
• Reduces bandwidth consumption by advertising only incremental updates. BGP is very suitable
to advertise large numbers of routes on the Internet.
• Eliminates routing loops by adding AS path information to BGP route updates.
• Uses policies to implement flexible route filtering and selection.
• Has good scalability.
BGP speaker and BGP peer
A router running BGP is a BGP speaker. A BGP speaker establishes peer relationships with other
BGP speakers to exchange routing information over TCP connections.
BGP peers include the following types:
• IBGP peers—Reside in the same AS as the local router.
• EBGP peers—Reside in different ASs from the local router.
BGP message types
BGP uses the following message types:
• Open—After establishing a TCP connection, BGP sends an Open message to establish a
session with the peer.
• Update—BGP sends update messages to exchange routing information between peers. Each
update message can advertise a group of feasible routes with identical attributes and multiple
withdrawn routes.
• Keepalive—BGP sends Keepalive messages between peers to maintain connectivity.
• Route-refresh—BGP sends a Route-refresh message to request the routing information of a
specified address family from a peer.
• Notification—BGP sends a Notification message upon detecting an error and immediately
closes the connection.
BGP path attributes
BGP uses the following path attributes in update messages for route filtering and selection:
• ORIGIN

Table of Contents

Other manuals for HPE FlexNetwork 5510 HI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE FlexNetwork 5510 HI Series and is the answer not in the manual?

HPE FlexNetwork 5510 HI Series Specifications

General IconGeneral
BrandHPE
ModelFlexNetwork 5510 HI Series
CategorySwitch
LanguageEnglish

Related product manuals