HPE FlexNetwork 5510 HI Series Layer 3 - Ip Routing Configuration Guide

134
Step Command Remarks
3. Configure P2P network type for
an interface.
isis circuit-type p2p
By default, the network type of
an interface depends on the
physical media. The network
type of a VLAN interface is
broadcast.
Configuring IS-IS route control
Configuration prerequisites
Before the configuration, complete the following tasks:
• Configure IP addresses for interfaces to ensure IP connectivity between neighboring nodes.
• Enable IS-IS.
Configuring IS-IS link cost
The IS-IS cost of an interface is determined in the following order:
1. IS-IS cost specified in interface view.
2. IS-IS cost specified in system view.
The cost is applied to the interfaces associated with the IS-IS process.
3. Automatically calculated cost.
If the cost style is wide or wide-compatible, IS-IS automatically calculates the cost using the
formula: Interface cost = (Bandwidth reference value / Expected interface bandwidth) × 10, in
the range of 1 to 16777214. For other cost styles, Table 13 ap
plies.
Configure the expected bandwidth of an interface with the bandwidth command. For more
information, see Interface Command Reference.
Table 13 Automatic cost calculation scheme for cost styles other than wide and
wide-compatible
Interface bandwidth Interface cost
≤ 10 Mbps 60
≤ 100 Mbps 50
≤ 155 Mbps 40
≤ 622 Mbps 30
≤ 2500 Mbps 20
> 2500 Mbps 10
4. If none of the above costs is used, a default cost of 10 applies.
Configuring an IS-IS cost for an interface
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter IS-IS view.
isis
[ process-id ] [
vpn-instance
vpn-instance-name ]
N/A

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English