HPE FlexNetwork 5510 HI Series Layer 3 - Ip Routing Configuration Guide

31
Step Command Remarks
3. Configure the filtering of
received routes.
filter-policy
{ acl-number |
gateway
prefix-list-name |
prefix-list
prefix-list-name [
gateway
prefix-list-name ] }
import
[ interface-type interface-number ]
By default, the filtering of
received routes is not
configured.
This command filters received
routes. Filtered routes are not
installed into the routing table or
advertised to neighbors.
4. Configure the filtering of
redistributed routes.
filter-policy
{ acl-number |
prefix-list
prefix-list-name }
export
[ protocol
[ process-id ] | interface-type
interface-number ]
By default, the filtering of
redistributed routes is not
configured.
This command filters
redistributed routes, including
routes redistributed with the
import-route
command.
Configuring a preference for RIP
If multiple IGPs find routes to the same destination, the route found by the IGP that has the highest
priority is selected as the optimal route. Perform this task to assign a preference to RIP. The smaller
the preference value, the higher the priority.
To configure a preference for RIP:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter RIP view.
rip
[ process-id ] [
vpn-instance
vpn-instance-name ]
N/A
3. Configure a preference for
RIP.
preference
[
route-policy
route-policy-name ] value
The default setting is 100.
Configuring RIP route redistribution
Perform this task to configure RIP to redistribute routes from other routing protocols, including OSPF,
IS-IS, BGP, static, and direct.
To configure RIP route redistribution:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter RIP view.
rip
[ process-id ] [
vpn-instance
vpn-instance-name ]
N/A
3. Redistribute routes from
another routing protocol.
import-route
protocol
[ process-id |
all-processes
|
allow-ibgp
] [
cost
cost |
route-policy
route-policy-name |
tag
tag ] *
By default, RIP route
redistribution is disabled.
This command can redistribute
only active routes. To view active
routes, use the
display ip
routing-table protocol
command.
4. (Optional.) Configure a
default cost for redistributed
routes.
default cost
value The default setting is 0.

HPE FlexNetwork 5510 HI Series Specifications

General

Brand	HPE
Model	FlexNetwork 5510 HI Series
Category	Switch
Language	English