EasyManuals Logo

HPE FlexNetwork 5510 HI Series Layer 3 - Ip Routing Configuration Guide

HPE FlexNetwork 5510 HI Series
486 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
23
Configuring a default route
A default route is used to forward packets that do not match any specific routing entry in the routing
table. Without a default route, packets that do not match any routing entries are discarded.
A default route can be configured in either of the following ways:
• The network administrator can configure a default route with both destination and mask being
0.0.0.0. For more information, see "Configuring a static route."
• Some dynamic routing protocols, such as OSPF, RIP, and IS-IS, can generate a default route.
For example, an upstream router running OSPF can generate a default route and advertise it to
other routers. These routers install the default route with the next hop being the upstream router.
For more information, see the respective chapters on these routing protocols in this
configuration guide.

Table of Contents

Other manuals for HPE FlexNetwork 5510 HI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE FlexNetwork 5510 HI Series and is the answer not in the manual?

HPE FlexNetwork 5510 HI Series Specifications

General IconGeneral
BrandHPE
ModelFlexNetwork 5510 HI Series
CategorySwitch
LanguageEnglish

Related product manuals