407
Step Command Remarks
2. Create an IPv6 policy
or policy node, and
enter IPv6 policy
node view.
ipv6 policy-based-route
policy-name
[
deny
|
permit
]
node
node-number
By default, no IPv6 policy
node is created.
Configuring match criteria for an IPv6 node
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter IPv6 policy
node view.
ipv6 policy-based-route
policy-name
[
deny
|
permit
]
node
node-number
N/A
3. Configure an ACL
match criterion.
if-match acl
{ acl6-number |
name
acl6-name }
By default, no ACL
match criterion is
configured.
NOTE:
An ACL match criterion uses the specified ACL to match packets regardless of the permit or deny
action and the time range of the ACL. If the specified ACL does not exist, no packet can match the
criterion.
Configuring actions for an IPv6 node
Step Command Remarks
1. Enter system
view.
system-view
N/A
2. Enter IPv6 policy
node view.
ipv6 policy-based-route
policy-name
[
deny
|
permit
]
node
node-number
N/A
3. Set next hops for
permitted IPv6
packets.
apply next-hop
[
vpn-instance
vpn-instance-name ] { ipv6-address
[
direct
] [
track
track-entry-number ] }&<1-n>
By default, no next hop is specified.
You can specify multiple next hops
for backup by executing this
command once or multiple times.
You can specify a maximum of two
next hops for a node.
Configuring IPv6 PBR
Configuring IPv6 local PBR
Configure IPv6 PBR by applying a policy locally. IPv6 PBR uses the policy to guide the forwarding of
locally generated packets. The specified policy must already exist. Otherwise, the IPv6 local PBR
configuration fails.
You can apply only one policy locally. Before you apply a new policy, you must first remove the
current policy.
IPv6 local PBR might affect local services, such as ping and Telnet. Do not configure IPv6 local PBR
unless doing so is required.
To Next Page
Loading...
Need help?
General
