10
Step Command Remarks
2. Configure BFD
control mode for a
static route.
• Method 1:
ip route-static dest-address { mask-length |
mask } { next-hop-address bfd control-packet
bfd-source ip-address | vpn-instance
d-vpn-instance-name next-hop-address bfd
control-packet bfd-source ip-address }
[ preference preference-value ] [ tag
tag-value ] [ description description-text ]
• Method 2:
ip route-static vpn-instance
s-vpn-instance-name dest-address
{ mask-length | mask } { next-hop-address bfd
control-packet bfd-source ip-address |
vpn-instance d-vpn-instance-name
next-hop-address bfd control-packet
bfd-source ip-address } [ preference
preference-value ] [ tag tag-value ]
[ description description-text ]
By default, BFD control
mode for a static route is
not configured.
Single-hop echo mode
With BFD echo mode enabled for a static route, the output interface sends BFD echo packets to the
destination device, which loops the packets back to test the link reachability.
IMPORTANT:
Do not use BFD for a static route with the output interface in spoofing state.
To configure BFD echo mode for a static route:
Step Command Remarks
1. Enter system view. system-view
N/A
2. Configure the
source address of
echo packets.
bfd echo-source-ip
ip-address
By default, the source
address of echo packets is
not configured.
For more information about
this command, see High
Availability Command
Reference.
3. Configure BFD echo
mode for a static
route.
• Method 1:
ip route-static dest-address { mask-length |
mask } interface-type interface-number
next-hop-address bfd echo-packet
[ preference preference-value ] [ tag
tag-value ] [ description description-text ]
• Method 2:
ip route-static vpn-instance
s-vpn-instance-name dest-address
{ mask-length | mask } interface-type
interface-number next-hop-address bfd
echo-packet [ preference
preference-value ] [ tag tag-value ]
[ description description-text ]
By default, BFD echo mode
for a static route is not
configured.
To Next Page
Loading...
Need help?
General