12
Step Command Remarks
3. Configure static route
FRR.
• Method 1:
ip route-static dest-address
{ mask-length | mask } interface-type
interface-number [ next-hop-address
[ backup-interface interface-type
interface-number [ backup-nexthop
backup-nexthop-address ] ] ]
[ permanent ]
• Method 2:
ip route-static vpn-instance
s-vpn-instance-name dest-address
{ mask-length | mask } interface-type
interface-number [ next-hop-address
[ backup-interface interface-type
interface-number [ backup-nexthop
backup-nexthop-address ] ] ]
[ permanent ]
By default, static route FRR
is not configured.
Configuring static route FRR to automatically select a backup next hop
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Configure the source
address of BFD echo
packets.
bfd echo-source-ip
ip-address
By default, the source address of
BFD echo packets is not
configured.
For more information about this
command, see High Availability
Command Reference.
3. Configure static route FRR to
automatically select a
backup next hop.
ip route-static fast-reroute auto
By default, static route FRR is
disabled.
Enabling BFD echo packet mode for static route FRR
By default, static route FRR does not use BFD to detect primary link failures. Perform this task to
enable static route FRR to use BFD echo packet mode for fast failure detection on the primary link.
To enable BFD echo packet mode for static route FRR:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Configure the source IP
address of BFD echo
packets.
bfd echo-source-ip
ip-address
By default, the source IP address
of BFD echo packets is not
configured.
3. Enable BFD echo packet
mode for static route FRR.
ip route-static
primary-path-detect bfd echo
By default, BFD echo mode for
static route FRR is disabled.
Displaying and maintaining static routes
Execute display commands in any view.
Task Command
Display static route information.
display ip routing-table
protocol
static
[
inactive
|
verbose
]
To Next Page
Loading...
Need help?
General
