EasyManuals Logo

HPE FlexNetwork 5510 HI Series Layer 3 - Ip Routing Configuration Guide

HPE FlexNetwork 5510 HI Series
486 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #407 background imageLoading...
Page #407 background image
396
Tuning and optimizing IPv6 IS-IS networks
Configuration prerequisites
Before you tune and optimize IPv6 IS-IS networks, complete basic IPv6 IS-IS tasks.
Assigning a convergence priority to IPv6 IS-IS routes
A topology change causes IS-IS routing convergence. To improve convergence speed, you can
assign convergence priorities to IPv6 IS-IS routes. Convergence priority levels are critical, high,
medium, and low. The higher the convergence priority, the faster the convergence speed.
By default, IPv6 IS-IS host routes have medium convergence priority, and other IPv6 IS-IS routes
have low convergence priority.
To assign a convergence priority to specific IPv6 IS-IS routes:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enter IS-IS view.
isis
[ process-id ] [
vpn-instance
vpn-instance-name ]
N/A
3. Assign a convergence
priority to specific IPv6 IS-IS
routes.
ipv6 priority
{
critical
|
high
|
medium
} {
prefix-list
prefix-list-name |
tag
tag-value }
By default, IPv6 IS-IS routes,
except IPv6 IS-IS host routes,
have the low convergence priority.
Configuring BFD for IPv6 IS-IS
Bidirectional forwarding detection (BFD) can quickly detect faults between IPv6 IS-IS neighbors to
improve the convergence speed of IPv6 IS-IS. For more information about BFD, see High Availability
Configuration Guide.
To configure BFD for IPv6 IS-IS:
Step Command Remarks
1. Enter system view.
system-view
N/A
2. Enable an IS-IS process and
enter IS-IS view.
isis
[ process-id ] [
vpn-instance
vpn-instance-name ]
N/A
3. Configure the NET for the
IS-IS process.
network-entity
net
By default, no NET is configured.
4. Enable IPv6 for the IS-IS
process.
ipv6 enable
By default, IPv6 for the IS-IS
process is disabled.
5. Return to system view.
quit
N/A
6. Enter interface view.
interface
interface-type
interface-number
N/A
7. Enable IPv6 for IS-IS on the
interface.
isis ipv6 enable
[ process-id ]
By default, IPv6 is disabled for
IS-IS on an interface.
8. Enable BFD for IPv6 IS-IS.
isis ipv6 bfd enable
By default, BFD for IPv6 IS-IS is
disabled.

Table of Contents

Other manuals for HPE FlexNetwork 5510 HI Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HPE FlexNetwork 5510 HI Series and is the answer not in the manual?

HPE FlexNetwork 5510 HI Series Specifications

General IconGeneral
BrandHPE
ModelFlexNetwork 5510 HI Series
CategorySwitch
LanguageEnglish

Related product manuals