410
# Configure the IPv6 address of VLAN-interface 10.
[SwitchB] interface vlan-interface 10
[SwitchB-Vlan-interface10] ipv6 address 1::2 64
3. Configure Switch C:
# Create VLAN 20.
<SwitchC> system-view
[SwitchC] vlan 20
[SwitchC-vlan20] quit
# Configure the IPv6 address of VLAN-interface 20.
[SwitchC] interface vlan-interface 20
[SwitchC-Vlan-interface20] ipv6 address 2::2 64
Verifying the configuration
# Telnet to Switch B on Switch A. The operation succeeds.
# Telnet to Switch C on Switch A. The operation fails.
# Ping Switch C from Switch A. The operation succeeds.
Telnet uses TCP, and ping uses ICMP. The results show the following:
• All TCP packets sent from Switch A are forwarded to the next hop 1::2.
• Other packets are forwarded through VLAN-interface 20.
• The IPv6 local PBR configuration is effective.
Packet type-based IPv6 interface PBR configuration example
Network requirements
As shown in Figure 100, configure IPv6 PBR on Switch A to forward all TCP packets received on
VLAN-interface 11 to the next hop 1::2. Switch A forwards other IPv6 packets according to the
routing table.
To Next Page
Loading...
