Hypertherm Powermax 125 Service Manual

218 Powermax125 Service Manual 808070
9 – Power Supply Component Replacement
Figure 79
9. Complete the following procedures:
a. See Install the fan shroud on page 216.
b. See Install the end panel bracket on page 175.
c. See Install the power supply cover on page 172.
d. Reconnect the power and gas supply.
1
2
1
3
4
1 Mounting screw locations
2 Fan flange
3 Fan wire
4 Left grommet

Hypertherm Powermax 125 Specifications

General

Output Current	30-125 A
Input Power	15.2 kW
Open Circuit Voltage	300 VDC
Gas Supply	Clean, dry, oil-free air or nitrogen
Input Power Cable Length	10 ft (3 m)
Rated Output Current	125 A
Gas Type	Air or nitrogen
Cutting Capacity	1-1/4 inch (32 mm)
Pierce Capacity	1 inch (25 mm)
Input Voltage	200-600 V, 3-PH
Duty Cycle	100% @ 125 A
Certifications	CSA
Maximum Clean Cut Thickness	1-1/4 inch (32 mm)
Cooling Method	Fan-cooled
Torch Options	Hand