Hypertherm Powermax 125 Service Manual

Powermax125 Service Manual 808070 57
Section 5
Hand Cutting
Using the hand torch
WARNING!
INSTANT-ON TORCHES
PLASMA ARC CAN CAUSE INJURY AND BURNS
Plasma arc comes on immediately when the torch trigger is activated. The plasma arc will cut quickly
through gloves and skin.
 Wear correct and appropriate protective equipment.
 Keep hands, clothing, and objects away from the torch tip.
 Do not hold the workpiece and keep your hands clear of the cutting path.
 Never point the torch toward yourself or others.

Hypertherm Powermax 125 Specifications

General

Output Current	30-125 A
Input Power	15.2 kW
Open Circuit Voltage	300 VDC
Gas Supply	Clean, dry, oil-free air or nitrogen
Input Power Cable Length	10 ft (3 m)
Rated Output Current	125 A
Gas Type	Air or nitrogen
Cutting Capacity	1-1/4 inch (32 mm)
Pierce Capacity	1 inch (25 mm)
Input Voltage	200-600 V, 3-PH
Duty Cycle	100% @ 125 A
Certifications	CSA
Maximum Clean Cut Thickness	1-1/4 inch (32 mm)
Cooling Method	Fan-cooled
Torch Options	Hand