Hypertherm Powermax 125 Service Manual

Powermax125 Service Manual 808070 293
Section 11
Parts
Use the Hypertherm kit numbers in this section to order replacement parts, consumables, and accessories for your power
supply, hand torch, and machine torch.
You can find procedures explaining how to install these kits in Power Supply Component Replacement on page 165 and
Torch Component Replacement on page 265.
For instructions on installing the consumables in the hand torches, see Install the hand torch consumables on page 54.
For instructions on installing the consumables in the machine torches, see Install the machine torch consumables on
page 75.

Hypertherm Powermax 125 Specifications

General

Output Current	30-125 A
Input Power	15.2 kW
Open Circuit Voltage	300 VDC
Gas Supply	Clean, dry, oil-free air or nitrogen
Input Power Cable Length	10 ft (3 m)
Rated Output Current	125 A
Gas Type	Air or nitrogen
Cutting Capacity	1-1/4 inch (32 mm)
Pierce Capacity	1 inch (25 mm)
Input Voltage	200-600 V, 3-PH
Duty Cycle	100% @ 125 A
Certifications	CSA
Maximum Clean Cut Thickness	1-1/4 inch (32 mm)
Cooling Method	Fan-cooled
Torch Options	Hand