Hypertherm Powermax 125 Service Manual

Powermax125 Service Manual 808070 303
11 – Parts
Hand torch consumables
Drag cutting
Gouging
FineCut
Part Number Description
420172 Duramax Hyamp shield 45/65 A
420000 Duramax Hyamp shield 105/125 A
220977 Duramax Hyamp retaining cap
420158 Duramax Hyamp nozzle 45 A
420169 Duramax Hyamp nozzle 65 A
220975 Duramax Hyamp nozzle 105/125 A
220971 Duramax Hyamp electrode
220997 Duramax Hyamp swirl ring
Part Number Description
420112 Duramax Hyamp gouging shield
220977 Duramax Hyamp retaining cap
420001 Duramax Hyamp gouging nozzle
220971 Duramax Hyamp electrode
220997 Duramax Hyamp swirl ring
Part Number Description
420152 Duramax Hyamp FineCut shield
220977 Duramax Hyamp retaining cap
420151 Duramax Hyamp FineCut nozzle
220971 Duramax Hyamp electrode
420159 Duramax Hyamp FineCut swirl ring

Hypertherm Powermax 125 Specifications

General

Output Current	30-125 A
Input Power	15.2 kW
Open Circuit Voltage	300 VDC
Gas Supply	Clean, dry, oil-free air or nitrogen
Input Power Cable Length	10 ft (3 m)
Rated Output Current	125 A
Gas Type	Air or nitrogen
Cutting Capacity	1-1/4 inch (32 mm)
Pierce Capacity	1 inch (25 mm)
Input Voltage	200-600 V, 3-PH
Duty Cycle	100% @ 125 A
Certifications	CSA
Maximum Clean Cut Thickness	1-1/4 inch (32 mm)
Cooling Method	Fan-cooled
Torch Options	Hand