Hypertherm Powermax 125 - Replacing the Torch Lead

Powermax125 Service Manual 808070 281
10 – Torch Component Replacement
Replacing the torch lead
1. Complete the following procedures:
a. See Disconnect the power, gas supply, and torch on page 266.
b. Remove all components from the torch. See Remove the handle on page 269.
2. Disconnect the cap-sensor switch and start switch.
Figure 138
3. Remove the pilot terminal screw.
Figure 139
Kit Description
428159 Kit: Duramax Hyamp hand torch lead replacement, 7.6 m (25 foot)
428160 Kit: Duramax Hyamp hand torch lead replacement, 15 m (50 foot)
428161 Kit: Duramax Hyamp hand torch lead replacement, 23 m (75 foot)
Cap-sensor switch
Tab
Tab
Start switch