Hypertherm Powermax45 XP User Manual

Routine Maintenance
11
Powermax45 XP Operator Manual 809240 157
13. Put the air filter bowl back into place by screwing the
metal guard into the air filter assembly that is inside the
power supply.

Make sure the air filter bowl remains straight as
you install it. Otherwise, you may damage the
threads on the bowl.
14. Reconnect the gas supply to the back of the power
supply.
15. Reconnect the power cord, and set the power switch to
ON (I).
ARC WELDING SUPPLIES - 07 847 7870

Hypertherm Powermax45 XP Specifications

General

Output Current	10-45 A
Gas Supply	Clean, dry, oil-free air or nitrogen
Torch Style	Handheld or mechanized
Input Voltage	50/60 Hz
Cutting Thickness	12 mm (1/2")
Cutting Capacity	16 mm (5/8 in)
Recommended Gas Inlet Flow Rate/Pressure	6.2 bar