Display Messages
151
ENERGY SAVER MODE
Status message: the printer is in
low-energy idle state, all fans and
higher voltages are off, only
+5VDC logic circuits are active.
No action required.
E Net Test Unavailable The Ethernet PCBA did not
initialize correctly.
1. Cycle power. Wait for “E Net Ready” to display, then retry
operation. If it still fails, power down, unplug the printer, and
reseat the ethernet NIC in its PCI slot.
2. Print the Ethernet Test Page from the Operator Print Tests.
3. Verify that the IP address, subnet mask, and default gateway
address are correct in the printout.
4. Verify that the IP address can be “pinged.”
5. If the message still appears, replace the ethernet NIC.
Table 3. Message List
Operator Panel Message Explanation Corrective Action
To Next Page
Loading...
