IBM Infoprint 6500-v05 User Manual

Chapter 1 Start Of Call
40
Start Of Call
Are you here because of an
error message?
YES
NO
Go to Troubleshooting Display
Messages, page 42.
NO
Did the fans come on after 10
seconds?
YES
After about 10
seconds did the
fans come on ?
YES
YES
NO
IML was
successful.
Other
symptoms are
listed in Table
5, page 176.
Go to Printer does not
complete IML, page 185.
Did ANY of steps 1 thru 3
occur?
NO
Press STOP.
Press CONFIG.
Press START.
Does machine
configuration print?
YES
NO
Go to the Operator Panel
section of Table 5, page
176
The Operator Panel is
not functioning (Table
5 page 176)
—OR—
Printer does not
complete IML, page
185.
Go to No power, and
operator panel is blank,
and card cage fan is not
running, page 184.
YES
NO
Are there black
squares on the
operator panel?
NO
Go to Printer does not
complete IML, page 185.
YES
Go to Black
squares on
operator panel
display, page
180.
Power on the printer and
observe the operator panel for
the following sequence of
events (retry as required):
1. All black squares appear on
the display.
2. Display goes blank.
3. The following messages
appear on the display, in this
order:
B00 STATUS: SDRAM
DETECTION 33MHZ
B01 STATUS: 8245
SDRAM TEST 32MB
B51 STATUS: XX%
LOADING
B30: STATUS INITIALIZING...
Did steps 1, 2, and 3 occur?
Did the status
lamp come on
and READY
appear on the
display? (If
default is NOT
READY, status
lamp will not
come on.)
YES
NO

IBM Infoprint 6500-v05 Specifications

General

Brand	IBM
Model	Infoprint 6500-v05
Category	Printer
Language	English