Ethernet Initialization
389
Ethernet Initialization
To initialize the ethernet interface, do the following steps:
1. Power on the printer.
2. Wait for “READY / ETHERNET ADAPTER IS READY” to display on the LCD.
3. If the printer is in the READY state, press the STOP key. The printer must be in the NOT READY state to do this procedure.
4. Press MENU + CONFIG + SCROLL ↑ + SCROLL ↓. (Press all four keys at the same time.)
“SERVICE / PRINTER MECHANISM TESTS” appears on the display.
5. Press RETURN + ENTER to unlock the ENTER key.
6. Press the SCROLL ↑ or SCROLL ↓ key until “SERVICE / PRINTER MGMT” appears on the display.
7. Press ENTER. “PRINTER MGMT / DIAGNOSTIC PORT” appears on the display.
8. Press ENTER. “DIAGNOSTIC PORT” (and the current diagnostic port setting) appears on the display. If the current setting
is “DEBUG ETHERNET*”, go to step 11.
9. Press SCROLL ↑ until “DIAGNOSTIC PORT / DEBUG ETHERNET” appears on the display.
10. Press Enter. An asterisk (*) appears next to the selection, indicating it is now the diagnostic port.
11. Press RETURN + ENTER to lock the ENTER key.
12. Press STOP to exit the menu and put the printer in the NOT READY state.
13. Power off the printer, wait a few seconds, then power on the printer to activate the new diagnostic port.
To Next Page
Loading...
Need help?
General
