484
34. If the paper you will use is not wider than 15.5 inches (39.5 cm) install the wire paper tent in the pull out paper tray.
(Figure 81.) If the paper is wider than 15.5 inches (39.5 cm) leave the paper tent out of the printer.
Figure 81. This figure shows how to install the paper tent in the paper tray.
35. Install the paper path that you removed in step 4.
36. Install paper and test stacker operation.
Paper Tent
Paper Tray
A
A
Note the positions of
the alignment tab and
the paper fence.
To Next Page
Loading...
