IBM Professional Series - Page 153

You install the remote server in three parts:
You load the
HEXIN program in source code form using
the EDIT command
on your remote VM system,
assemble it, and the
HEXIN module is then created.
You load the
TEXT files needed to generate the
VMPCSERV module to your remote system using the
HEXIN module.
You use these
TEXT files to create the VMPCSERV
module, and Upload the VMPCSERV exec using the
EDIT command on your remote VM system.
You will need approximately
200 blocks of space on your
Remote System's A-disk to Upload the Remote
Server files
(if your A-disk
is formatted in 1024-byte blocks).
The remote server program is contained
on distribution
diskette 3. Follow these steps to install it:
Step 1 - Bring up VM/PC (it is assumed that you have
already installed
VM/PC; if not, refer to Chapter 2 for
that procedure).
• Step 2 - From the Session Selection Menu, select the
Remote 3277 Session.
• Step 3 - Logon to your remote VM system, IPL CMS,
and enter the following commands (they may be
executed from an
EXEC if you prefer):
GLOBAL MACLIB DMSSP CMSLIB (or the
maclib names
on your remote system which contain
the
CMS macros)
CP SET MSG OFF
CP SET WNG OFF
CP SET ACNT OFF
CP TERMINAL ESCAPE OFF LINEND OFF
LINEDEL OFF LINE SIZE 80
6-4 VM/PC Users Guide