IBM Professional Series User Manual

EOL or NOEOL
Notes:
EOL specifies that end-of-line characters (carriage
return/line feed) are to be inserted into the target
file to delimit the lines of the file.
NOEOL specifies
that the target file
is to be created without inserting
end-of-line characters to delimit lines of the file.
EOL is the default.
1. The EXPORT command may create a temporary file
called
"EXPORT.CMS" during the export of the CMS
file. Any file which you have on the target disk called
"EXPORT.CMS" will be erased if the EXPORT
command is used.
2. The
CMS file to be exported must have a logical record
length of 65535
or less if the EOL option is to be used.
If the LRECL of the file exceeds this, it cannot be
exported with the
EOL option.
3. A file which has been exported, translated to
ASCII, and
subsequently imported may differ from the original file,
due to the translate tables used in the file
transformations. The
NOASCII options should be used
to avoid problems caused by this transformation.
Appendix E,
"ASCII to EBCDIC Conversion" on page
E-1 lists the EBCDIC-ASCII conversion tables which
are used in this translation.
Messages and Return Codes:
DMSEXP002E File 'fn ft fm not found RC=28
DMSEXP003E Invalid option 'option' RC=24
DMSEXP024E File 'd:filename.ext' already exists
specify 'replace' RC=28
DMSEXp042E No fileid(s) specified RC=24
DMSEXp048E Invalid mode 'mode' RC=24
DMSEXP054E Incomplete fileid specified RC=24
DMSEXp062E Invalid * in fileid RC=20
DMSEXP070E Invalid parameter 'parameter' RC=24
DMSEXP104E Error 'nn' reading file 'fn ft fm' from disk RC=100
DMSEXp622E Insufficient storage available RC=41
DMSEXp800E Invalid export of a CMS file to a system file RC=100
DMSEXp804E Invalid PC fileid 'd:filename.ext' specified RC=20
DMSEXp806E Export terminated, insufficient disk
space available RC=32
DMSEXp807S Drive d not ready. Make drive ready and press enter
DMSEXp808s File cannot be exported with the 'EOl' option RC=20
DMSEXP907E 1/0 error on file 'd:filename.ext' RC=256
DMSSTT048E Invalid mode 'mode' RC=24
DMSSTT062E Invalid character 'char' in fileid 'fn ft fm' RC=20
DMSSTT069E Disk 'mode' not accessed RC=36
Chapter 7. VM/PC Commands 7 -77

IBM Professional Series Specifications

General

Brand	IBM
Model	Professional Series
Category	Software
Language	English