IBM
3101
EMULATION
PROGRAM
SELECTION
MENU
Press
the
number
of
the
program
that
you
want: _
then,
press
ENTER.
1 Terminal Value
Specification
Program
2 Terminal Emulation Program
3
File
Conversion Program
Figure
4-4.3101
Emulation Program Selection Menu
The Terminal Value Specification Program
is
used to select,
modify
or
create a specification file for use by the Terminal
Emulation Program.
Press
the"
1"
key to run the Terminal
Value Specification Program.
VM/PC
will then load this
program (using the default
DOS file name of
C:SETUP.EXE) and give it control
of
the Remote 3101
Session.
The Terminal Emulation Program
is
used to actually
communicate with another computer over the
RS232
communications interface. Press the
"2"
key to run the
Terminal Emulation Program.
VM/PC
will then load this
program (using the default
DOS file name of
C:TERMINAL.EXE)
and
give it control of the Remote
3101 Session.
The File Conversion Program
is
used to convert ASCII
format files to or from binary format files. The files involved
in the conversion must
be
regular DOS files,
but
they can be
on
the fixed disk(s) or
on
diskette(s). Press the
"3"
key to
run the File Conversion Program.
VM/PC
will then load
this program (using the default
DOS file name of
C:FILECONV.EXE)
and give it control of the Remote 3101
Session.
Once any
of
the three programs begins to run, its operation
is as described in the IBM
3101 Emulation Program
documentation.
Chapter 4. Getting Started
4-9
To Next Page
Loading...
Need help?
General
