IBM V7000 User Manual

Chapter 3. Systems management 119
There are minimum hardware and software requirements that the system must meet before
you can install or use IFM, which are documented in detail at the following website:
http://publib.boulder.ibm.com/infocenter/flexsys/information/topic/com.ibm.acc.iof
m.doc/dw1li_creating_a_configuration_file_automatically.html
For information regarding how to install, configure, and use IBM Fabric Manager (IFM), visit
this website:
http://publib.boulder.ibm.com/infocenter/flexsys/information/topic/com.ibm.acc.iof
m.doc/dw1li_advanced.html
3.3.3 Logging in to the IBM Flex System Manager Node
The following section gives step-by-step instructions regarding how to log in to the FSM:
1. Open a web browser, and type in the IP address of the FSM. Remember that depending
on the security style, it might be necessary to use https protocol.
2. At the Login panel, enter your User name and Password. Figure 3-45 shows the FSM
login page.
Figure 3-45 IBM Flex System Manager login panel

IBM V7000 Specifications

General

Model	IBM Storwize V7000
Storage Type	Hybrid Flash Array
Maximum Capacity	1.2PB
RAID Levels	0, 1, 5, 6, 10
Connectivity	8 Gbps Fibre Channel, 16 Gbps Fibre Channel, 1 Gbps iSCSI, 10 Gbps iSCSI
Management	Command-line interface (CLI), Graphical user interface (GUI)
Form Factor	2U
Drive Bays	12
Maximum Raw Capacity	1.2PB
Operating System Support	AIX, HP-UX, Linux, VMware, Windows
Data Reduction Features	Real-time Compression, Deduplication
Drive Types	SSD, HDD
Scalability	Scale-up (drive enclosures) and scale-out (clustering) capabilities