538 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
Figure 12-38 shows the initialized FCoE attached Windows disk in the Disk Management
window.
Figure 12-38 Disk Management - FCoE attached disk formatted and online
The setup is now complete, and IBM Flex System V7000 Storage Node is mapping an FCoE
attached volume to the server. The Windows 2008 R2 server is prepared to access the
volumes over four paths and is able to store data on the storage subsystem.
For more information about FCoE, see Chapter 11, “SAN connections and configuration” on
page 457.
12.4 VMware ESX host attachment
In this section, we are covering VMware ESX host attachment for Fibre Channel (FC) and
iSCSI.
12.4.1 VMware ESX Fibre Channel attachment
To perform VMware ESX Fibre Channel attachment, complete the following steps:
1. Right-click your VMware ESX Fibre Channel host in the All Hosts view (Figure 12-39) and
select Properties.
To Next Page
Loading...
Need help?
General