IBM V7000 User Manual

626 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
13.13.1 Powering on the system
Follow this procedure to power on the system:
1. If the chassis is powered-off, physically go to the chassis and press the power switch.
Normally, this automatically causes power on to the Flex System V7000 Storage Node.
2. If the Flex System V7000 Storage Node does not automatically power on, use the CMM
(as shown in Figure 13-52) or FSM GUI / CLI to request power-on for the Flex System
V7000 Storage Node.
Figure 13-52 CMM actions for Node canister
3. Power on expansion enclosures before control enclosures, as shown in Figure 13-53.
Figure 13-53 CMM actions for Expansion canister
Click here to view
Actions window
Click here to view
Actions menu

IBM V7000 Specifications

General

Brand	IBM
Model	V7000
Category	Storage
Language	English