IBM V7000 User Manual

628 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
13.13.3 Shutting down using IBM Flex System V7000 Storage Node
command-line interface
You can also shut down IBM Flex System V7000 Storage Node by using the CLI and the
PuTTY utility. Run the stopcluster command to shut down the system.
13.13.4 Powering off a node using the CMM
Use this procedure when it is necessary to power off the Flex System V7000 Storage Node
using the CMM. Make sure you that select the correct node canister before proceeding.
Power off IBM Flex System V7000 Storage Node canister using the IBM Flex System V7000
Storage Node service GUI:
1. Open the CMM and navigate to the Chassis Map. The Chassis Map displayed by the CMM
provides a graphical view of the IBM Flex System Enterprise Chassis components. Using
the mouse, locate the node that you want to power off, as shown in Figure 13-52 on
page 626.
2. Click the node to display the Actions menu.
3. In the Actions menu, click Power Off. (Controller will shut down OS).
Caution: This operation can result in permanent loss of data on storage volumes or
loss of access to the volumes. Use the storage management user interface provided by
the storage node to power off the storage system or individual storage controllers.
Only continue if the service procedures have directed the use of this CMM power
control operation.

IBM V7000 Specifications

General

Model	IBM Storwize V7000
Storage Type	Hybrid Flash Array
Maximum Capacity	1.2PB
RAID Levels	0, 1, 5, 6, 10
Connectivity	8 Gbps Fibre Channel, 16 Gbps Fibre Channel, 1 Gbps iSCSI, 10 Gbps iSCSI
Management	Command-line interface (CLI), Graphical user interface (GUI)
Form Factor	2U
Drive Bays	12
Maximum Raw Capacity	1.2PB
Operating System Support	AIX, HP-UX, Linux, VMware, Windows
Data Reduction Features	Real-time Compression, Deduplication
Drive Types	SSD, HDD
Scalability	Scale-up (drive enclosures) and scale-out (clustering) capabilities