IBM V7000 User Manual

96 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
򐂰 To configure the IP address of a certain chassis component, click the component
(under Device Name), as shown in Figure 3-9.
Figure 3-9 IP Address Configuration
You can also view and configure IP addresses using IBM Flex System Manager as well as the
node-specific management controllers.
There are numerous functions and features offered by the IBM Flex System Chassis
Management Module that are beyond the scope of this publication. However, we cover the I/O
module access features in the next section, due to its relevance with storage management.
For detailed information regarding IBM Flex System Chassis Management Module
configuration capabilities, visit the following website:
http://publib.boulder.ibm.com/infocenter/flexsys/information/topic/com.ibm.acc.cmm
.doc/cmm_ui_config_the_cmm.html
Or, see Implementing Systems Management of IBM PureFlex System, SG24-8060.
3.2.4 Accessing I/O modules using CMM
The IBM Flex System Chassis Management Module performs end-to-end management of all
components in the solution. It allows many functions and features that can be performed on
I/O modules, as well as giving access to platform-based management interfaces of the
modules for in-depth management.

IBM V7000 Specifications

General

Model	IBM Storwize V7000
Storage Type	Hybrid Flash Array
Maximum Capacity	1.2PB
RAID Levels	0, 1, 5, 6, 10
Connectivity	8 Gbps Fibre Channel, 16 Gbps Fibre Channel, 1 Gbps iSCSI, 10 Gbps iSCSI
Management	Command-line interface (CLI), Graphical user interface (GUI)
Form Factor	2U
Drive Bays	12
Maximum Raw Capacity	1.2PB
Operating System Support	AIX, HP-UX, Linux, VMware, Windows
Data Reduction Features	Real-time Compression, Deduplication
Drive Types	SSD, HDD
Scalability	Scale-up (drive enclosures) and scale-out (clustering) capabilities