170 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
For more details on the rest of the setup wizard steps, see 4.3, “IBM Flex System V7000
Storage Node Setup Wizard” on page 170.
4.3 IBM Flex System V7000 Storage Node Setup Wizard
After the initial configuration using the FSM or CMM, we can continue with the setup wizard
for the rest of the configuration of IBM Flex System V7000 Storage Node.
After clicking Finish in Figure 4-11 on page 169, on the next panel, enter the system name
and a new superuser password. At this point, you have the option to use the setup wizard to
configure more settings such as notifications and storage configuration. If you are not ready
to complete further configuration steps, use the configuration tasks in the management GUI
to complete the configuration at a later time.
When you complete the Initial Setup wizard, return to the FSM or CMM console.
1. After the initial configuration described in 4.2, “Initial setup for IBM Flex System V7000
Storage Node” on page 162 is complete, the IBM Flex System V7000 Storage Node
Welcome window opens (Figure 4-12).
Figure 4-12 IBM Flex System V7000 Storage Node Welcome window
Tip: It is recommended that you upgrade to the most current level of software after
installing the Flex System V7000 Storage Node. The management GUI can be used to
apply software updates. See the IBM Flex System V7000 Storage Node support website
for the latest information about software upgrades.
To Next Page
Loading...
Need help?
General
