Chapter 4. IBM Flex System V7000 Storage Node initial configuration 171
You are prompted to change the default password on this first login to the management
GUI, as shown in Figure 4-13.
Figure 4-13 Change default login password
The IBM Flex system v7000’s Welcome to System Setup window appears after a
successful login through the management GUI. Click Next to continue this initial setup
process, as shown in Figure 4-14.
Figure 4-14 IBM Flex system v7000’s Welcome to System Setup window
Note: During the initial setup of the Flex System V7000, the installation wizard asks for
various information that you should have created during planning and have available
during this installation process. If you do not have this information ready or choose not
to configure some of these settings during the installation process, you can configure
them later through the management GUI.
To Next Page
Loading...
