IBM V7000 User Manual

592 IBM Flex System V7000 Storage Node Introduction and Implementation Guide
13.4.3 Using CMM Chassis Manager to manage a storage node
The CMM Chassis Map view provides hardware and table views of all discovered resources
in a managed chassis. Use the Chassis Manager view in the management software web
interface to view Flex System V7000 details and perform management tasks. You can launch
Storage Node from CMM to perform tasks on the IBM Flex System V7000 Storage Node, as
shown in Figure 13-12.
Figure 13-12 Using CMM to launch IBM Flex System V7000 Storage Node
You can also click the Chassis Management tab and view properties and settings of the
following components installed in the chassis, such as Compute Node, Storage Node, I/O
Modules, Fans and Cooling, Power Modules and Management, Component IP configuration,
Chassis internal network, Hardware Topology, and also generate reports of hardware
information. Click Storage Node to view the storage control enclosure and storage expansion
enclosure. You may select and view details of one node at a time as shown in Figure 13-13.
Click to view Actions for canister
Click here to launch
Storage Node

IBM V7000 Specifications

General

Model	IBM Storwize V7000
Storage Type	Hybrid Flash Array
Maximum Capacity	1.2PB
RAID Levels	0, 1, 5, 6, 10
Connectivity	8 Gbps Fibre Channel, 16 Gbps Fibre Channel, 1 Gbps iSCSI, 10 Gbps iSCSI
Management	Command-line interface (CLI), Graphical user interface (GUI)
Form Factor	2U
Drive Bays	12
Maximum Raw Capacity	1.2PB
Operating System Support	AIX, HP-UX, Linux, VMware, Windows
Data Reduction Features	Real-time Compression, Deduplication
Drive Types	SSD, HDD
Scalability	Scale-up (drive enclosures) and scale-out (clustering) capabilities