IBM V7000 User Manual

Chapter 4. IBM Flex System V7000 Storage Node initial configuration 183
4.4.2 Launching IBM Flex System V7000 Storage Node GUI from CMM
When a new control enclosure is detected in the IBM Flex System Enterprise Chassis, the
Chassis Management Module (CMM) recognizes the new hardware and starts the
initialization process. The IBM Flex System V7000 Storage Node Management GUI can be
launched and accessed by CMM after the management IP been assigned to your new Flex
System V7000 storage node.
To start, log in to the CMM GUI and navigate to the Chassis Map. Right-click the canister that
you want to launch and select Launch Storage Node Controller Console to access the
Storage Node management GUI. See Figure 4-35.
Figure 4-35 To launch storage node controller console by Chassis Map
To launch the IBM Flex System V7000 Storage Node management GUI, select the Interface
IP address (Figure 4-36) and click Launch to start the Storage Node Controller Console.
Figure 4-36 Launch to start the Storage Node Controller Console

IBM V7000 Specifications

General

Brand	IBM
Model	V7000
Category	Storage
Language	English