IDEC MICRO/I HG1P-ST32 Series User Manual

WindO/I-NV4 User’s Manual 17-1
17
Preventive Maintenance Function
This chapter describes how to configure the Preventive Maintenance function and its operation on the MICRO/I.
1.1 How the Preventive Maintenance Function is Used
The Preventive Maintenance function monitors the state of device addresses and counts the time the monitored
device addresses are 1, as well as the number of times the values of monitored device addresses change to 1.
The Preventive Maintenance function can perform the following functions.
• Monitor device addresses that turn on lighting or warning lights and count the operation time
• Report the replacement time for lighting and warning lights by the counted operation time
• Monitor device addresses connected to buttons and relays and count the operation count
• Report the inspection time for buttons and relays by the counted operation count
Chapter 17 Preventive Maintenance Function
1Overview
HG3G HG2G-5FHG5G-V HG4G-V HG3G-V HG2G-V HG2G-5T HG4G HG1G HG1P
Lighting
Warning light
External device
MICRO/I
1230 hours
Lighting
360 hours
Warning
light
Lighting
Warning light
External device
MICRO/I
Please replace
Lighting
Replace soon
Warning
light
Button
Relay
External device
MICRO/I
123 times
Button
1000 times
Relay
Button
Relay
External device
MICRO/I
Button
Please inspect
Inspect soon
Relay

IDEC MICRO/I HG1P-ST32 Series Specifications

General

Brand	IDEC
Model	MICRO/I HG1P-ST32 Series
Category	Control Panel
Language	English