IDEC MICRO/I HG1P-ST32 Series User Manual

3 Uploading
24-20 WindO/I-NV4 User’s Manual
3 Check the project data details, and then click Upload.
If there is a project file with the same file name in the upload folder, an overwrite confirmation message is displayed.
•Click Yes to start uploading the project data.
•Click Cancel to stop uploading the project data.
When finished uploading, a completion message is displayed.
■ Project Name
The project is saved with the currently displayed name. To change the project name, enter a new name for the file.
The maximum number is 50 characters.
■ Location
The uploaded project file is saved to the currently displayed location. To change the location of the saved file,
click . The Browse folders dialog box is displayed. Select a location, and then click OK.
4 Click OK.
5 Click Close on the Upload dialog box.
A confirmation message to open the project is displayed.
You cannot use the following characters in the project name.
\ / : * ? " < > |

IDEC MICRO/I HG1P-ST32 Series Specifications

General

Brand	IDEC
Model	MICRO/I HG1P-ST32 Series
Category	Control Panel
Language	English