IDEC MICRO/I HG1P-ST32 Series User Manual

WindO/I-NV4 User’s Manual 31-27
2 USB Autorun Function
31
External Memory Devices
2 Press the command to execute.
The command executes.
3 When the command finishes executing, a screen appears indicating the execution result.
Press Ack to close the execution result screen and display the menu screen.
Production line A - replace
MICRO/I program
Copy MICRO/I program to USB
flash drive
Replace sound data Copy PLC program to USB
flash drive
Production line A - replace
PLC program
Run All Cancel
Confirmation
Press the command to execute.
•Pressing Run All causes all commands defined in the USB Autorun definition file (hgauto.ini) to execute
one by one.
• If security is enabled for the project on MICRO/I, a dialog appears for you to enter a user name and
password.
For details, refer to “2.4 USB Autorun Function Security” on page 31-36.
• When uploading or downloading IDEC PLC program to a password-protected PLC, a dialog appears for
you to enter the password.
Do not remove the USB flash drive or SD memory card while command is executing.
Production line A - replace
MICRO/I program
Function
The following function completed
Ack
Result
If a command executes with a button (except the Run All), the menu screen is displayed after pressing Ack
on the execution result dialog.

IDEC MICRO/I HG1P-ST32 Series Specifications

General

Brand	IDEC
Model	MICRO/I HG1P-ST32 Series
Category	Control Panel
Language	English