idp SMART-70 - Page 19

19
>>YScale
To set the length of printed image on the card’s Y-
axis.
>>TotalDensity
To set the total printing density.
>>ColorDensity
To set the color density
>>BlackDensity
To set the resin black density.
>>OverlayDensity
To set overlay density.
>>RMP+
To adjust the force for pulling print ribbon during
printing when the residual quantity of print ribbon is
in its maximum quantity.
>>RMP-
To adjust the force for pulling print ribbon during
printing when the residual quantity of print ribbon is
in its minimum quantity.
>>RMM+
To adjust the force for pulling print ribbon during
alignment when the residual quantity of print ribbon
is in its maximum quantity.
>>RMM-
To adjust the force for pulling print ribbon during
alignment when the residual quantity of print ribbon
is in its minimum quantity.
>>HeadResister
To set resistance value of TPH (Thermal Print Head).
>Operation
>>Print Sample
To print a sample card.
>Information
>>Printer Serial
To show the serial number of Printer.
>>Firmware Ver.
To show the firmware version of Printer.
>>Head Serial
To show the serial number of TPH.
>>Ribbon Balance
To show the print ribbon type and balance.
>>IP Address
To show the current IP address of Printer.
>>Network Mask
To show the current Network mask of Printer.
>>Gateway
To show the current Gateway of Printer.
>>MAC Address
To show the MAC address of Printer.
>>User Count
To show the number of issued cards that user can
reset.
>>Factory Count
To show the number of accumulated issued cards
after factory shipment.