idp SMART-70 - Output Hopper

25
Width is smaller, the distance of attached patch is
shorter. Default is 5950.
>>Lami Speed
To adjust the Laminating Speed[400 ~ 800].
As the value of Lami Speed is bigger, the
laminating speed is faster. As the value of Lami
Speed is smaller, the laminating speed is slower.
Default is 550.
>>Lami Torque+
To adjust the torque of motor to move a patch
when the residual quantity of patch is in its
maximum quantity [400 ~ 1000].
As the value of Lami Torque+ is bigger, the motor
moves with big force. As the value is smaller, the
motor moves with small force.
Default is 600.
>>Lami Torque-
To adjust the torque of motor to move a patch
when the residual quantity of patch is in its
minimum quantity [400 ~ 1000].
As the value of Lami Torque- is bigger, the motor
moves with big force. As the value is smaller, the
motor moves with small force.
Default is 700.
>Information
>>Lami. Version
To display the firmware version of Laminator.
>> Serial Number
To display the serial number of Laminator.
>>Film Type
To display the film type installed in Laminator.
>>Fac.Lami.Count
To display the laminating count after shipping
from factory.
>>UserLami.Count
To display the laminating count after user
initializes
>>User Count
To display the firmware version of Laminator.
>>Factory Count
To display the serial number of Laminator.
1.2.5 Output Hopper
SMART-70 Output Hopper can stack with 500 cards after printing, laminating and encoding.
SMART-70 Output Hopper has the following features.