This instruction manual is to be used in conjunction with the
in vitro diagnostic analyser and must be read before
installing or using the analyser.
in vitro diagnostic analyser must only be used by
personnel trained by approved IDS staff.
The purpose of the user manual is to explain:
•
The way the analyser works.
•
How to use it in routine working practice.
•
The preventive maintenance required.
Revision M1 of the User Manual was produced on the 21
st
December 2015, for the software
version:
V 14.04
The information contained in this document is applicable to any subsequent software version identified as «V
14.XX». Changes with the decimals of the version identifier are used to account for minor software
enhancements, concerning neither the features nor the use of the system.
The manual comprises the following sections and appendices:
Section 1: ! Operating Principle
Section 2: ! User Interface Software
Section 3: ! Use !
Section 4: ! Messages
Section 5:! Maintenance
Section 6:! Problems And Corrective Action
Section 7:! System Configuration
Appendix I:! Waste Disposal
Appendix II: !Decontaminating The Analyser
Appendix III: !Disposal Of The Analyser
Appendix IV: !IDS-iSYS Cuvettes
Appendix V: ! Sample barcode symbology managed by the system
Appendix VI: !Analyser long stoppage period
Attached document: Protocol for connection, revision N1
!
If the equipment is used in a manner not specified by the manufacturer, the protection provided
by the equipment may be impaired.
If the recommendations contained in this manual are not respected, the level of performance
offered by the analyser may be impaired and the results generated may be incorrect.
Preface
IDS-iSYS User Manual - Revision M1" P 1
Software version V 14
To Next Page
Loading...