IEI Technology WSB-H810 User Manual

WSB-H810 PICMG 1.0 CPU Card
Page 65
Setting Description
1-2 (down) ATX power mode (default)
2-3 (up) AT power mode
Table 4-1: AT/ATX Power Mode Switch Settings
4.9.2 Clear CMOS Button
To reset the BIOS, remove the on-board battery and press the clear CMOS button for
three seconds or more. The clear CMOS button location is shown in
Figure 4-18.
Figure 4-18: Clear CMOS Button Location
4.9.3 Flash Descriptor Security Override
The Flash Descriptor Security Override jumper (J_FLASH1) allows to enable or disable
the ME firmware update. Refer to
Figure 4-19 and Table 4-2 for the jumper location and
settings.
Setting Description
Short 1-2 Disabled (default)
Short 2-3 Enabled
Table 4-2: Flash Descriptor Security Override Jumper Settings

IEI Technology WSB-H810 Specifications

General

Brand	IEI Technology
Model	WSB-H810
Category	Motherboard
Language	English