WSB-H810 PICMG 1.0 CPU Card
Page 89
Î
IO=2E0h;
IRQ=10, 11
Serial Port I/O port address is 2E0h and the interrupt
address is IRQ10, 11
5.3.7.2 IrDA Configuration
Use the IrDA Configuration menu (BIOS Menu 11) to configure the infrared port.
Aptio Setup Utility – Copyright (C) 2010 American Megatrends, Inc.
Advanced
IrDA Configuration
Serial Port [Enabled]
Device Settings IO=2D8h; IRQ=10
Change Settings [Auto]
Duplex Function [Full Duplex]
Enable or Disable Serial
Port (COM)
---------------------
ÆÅ
: Select Screen
↑ ↓: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit
ESC: Exit
Version 2.15.1236. Copyright (C) 2012 American Megatrends, Inc.
BIOS Menu 11: IrDA Configuration Menu
Î Serial Port [Enabled]
Use the Serial Port option to enable or disable the infrared port.
Î
Disabled
Disable the infrared port
Î
Enabled DEFAULT
Enable the infrared port
Î Change Settings [Auto]
Use the Change Settings option to change the infrared port IO port address and interrupt
address.
Î
Auto DEFAULT
The infrared port IO port address and interrupt
address are automatically detected.
To Next Page
Loading...
Need help?
General
