Infors Multitron - Page 5

Multitron - Incubation Shaker
Table of Contents
25 February 2019 Page 3 of 146
4.9.2 Using the Cable Pass-through ..................... 48
5 Accessories .......................................................................... 49
5.1 Trays ............................................................................ 49
5.1.1 Universal Table Tray .................................... 49
5.1.2 Pre-Fitted Trays ............................................ 50
5.1.3 Tray with «Sticky Stuff» Adhesive Matting ... 55
5.2 Clamps and Other Holders .......................................... 59
5.2.1 Clamps ......................................................... 59
5.2.2 Test Tube Holders ........................................ 60
5.3 Box for Microtitre Plates ............................................... 61
5.4 Software ....................................................................... 64
5.4.1 eve
®
.............................................................. 64
6 Installation ............................................................................ 65
6.1 Operating Conditions at the Installation Location ........ 65
6.2 Requirements for the Mains Connection ..................... 66
6.3 Minimum Distances to the Equipment ......................... 67
7 Operation .............................................................................. 69
7.1 Switching on the Equipment ........................................ 69
7.2 Loading the Equipment ................................................ 69
7.2.1 Opening the Door ......................................... 69
7.2.2 Inserting and Removing the Tray ................. 70
7.2.3 Fitting the Holders ........................................ 73
7.2.4 Notices on Loading the Tray ........................ 75
7.3 Overview about the Display und Controls ................... 76
7.3.1 Display Area ................................................. 77
7.3.2 Signs and Messages Regarding the Timer
Function ........................................................ 78
7.3.3 Error, Warning, and Alarm Signs.................. 79
7.3.4 Operating Panel ........................................... 80
7.4 Adjusting, Activating and Deactivating Parameters ..... 81
7.4.1 Overview about the Parameters ................... 81
7.4.2 Setting the Parameter Setpoints .................. 84
7.4.3 Turning a Parameter On or Off..................... 85
7.5 Timer Function ............................................................. 86
7.5.1 Overview ....................................................... 86
7.5.2 Programming the Timer - Single Change ..... 91
7.5.3 Programming the Timer - Cyclic Change ..... 96
7.5.4 Changing Timer Settings during Activated
Timer Function ............................................. 97
7.5.5 Changing Parameter Setpoint Values
during Activated Timer Function................... 98